PPV1-4jpg.jpg
Vinyl2_edited.jpg

PPV1-4-Pre-Plate Vinyl 4 position

Stands for Pre-Plate system, specially designed for pre-plating a silvered lacquer max diameter 14” prior to be put in the high speed plating system. This unit runs at a lower temperature and lower current as in the high speed bath. This is to avoid crack in the lacquer master.

This pre-plate unit has a rocking sledge, this can be set  from 2 – 20 movements in a min., that can hold up to 4 silvered lacquers, each lacquer has its own current source that can be programmed independently. The current sources can be programmed by means of an 10” touch screen. The solution is temperature controlled and filtered continuously. Maximum agitation is achieved by spaying the solution between the anode basket and the silvered lacquers.

Specifications:

Dimensions : 1400 x 800 x 2200 mm W x D x H

Working height : 1000 mm

Minimum required floor space : 4 m², min. space at back of wet-bench 0,5 m for service purpose

Frame is made of : Stainless Steel

Work bench material : Polypropylene ( PP )

Electrical connection : 380/400 VAC , +/- 5%, 50/60Hz, 3 fase, 10 Amp fused

CEE-plug red 16A 5 pole, 3P+N+E

Power consumption : Max. 3000 Watts

Positions to be pre-plated : 4

Max. current on each pos. : 0 – 40 amp. Recommendation not to go above 20 Amps.

Rocking speed : 2 – 20 Movements/m., foot switch operated

Tank capacity : +/- 400 liter